Type I, II, III

TRANSMISSION BREAK-IN Procedure

NAG1 722.6 | 8HP90 | 8HP95 | 8HP70 | NAG2 722.9

!!ATTENTION!!

EXCESSIVE HEAT WILL DESTROY YOUR TRANSMISSION

DO NOT DYNO YOUR VEHICLE UNTIL THE TRANSMISSION BREAK-IN IS COMPLETE! 

ONLY USE SOUTHERN HOTROD LLC APPROVED TRANSMISSION FLUID *CLICK HERE*

8HPxx TRANSMISSION ADAPTATION AND QUICK LEARN PROCEDURE *CLICK HERE*

NAG1 TRANSMISSION ADAPTATION PROCEDURE (MOPAR) *CLICK HERE*

 

MAKE SURE TO START WITH A KNOWN GOOD TRANSMISSION CALIBRATION Verify correct fluid level and type Verify that no DTC's are present, e.g. Transmission, Engine, ABS, etc... Reset Transmission adaptation Perform "Quick Learn" 8HPxx only

Road test vehicle and verify transmission operation Recheck transmission fluid level Recheck that no DTC's are present

Drive Vehicle for a MINIMUM of 200mi / 320km at mild to moderate load  Make sure to go through all gears, Up and Down / extended operation in one gear is NOT recommended

Recheck transmission fluid level Recheck that no DTC's are present Break-In complete!

 

QUESTIONS? PLEASE VISIT OUR SUPPORT PAGE OR CALL US AT 888.244.4364

 

 

  v240822a